Stainless Steel Silver Hoop Earrings with Embossed Pattern

Stainless steel hoop earrings that fasten with a post, not a hinge

There is no hinge and no clip on this design. The straight post goes through the pierced lobe and the butterfly backs supplied hold it from behind, just as they would on a plain stud. At 3 centimetres across, the ring sits just below the lobe, so it shows from the front and from the side without catching on a high collar. You will find the rest of the range under steel earrings.

A band that grows wider on the way down

The metal is not the same width all the way round. It starts narrow beside the post, then widens steadily towards the bottom until it forms a clean crescent at the lowest point of the ring. That asymmetry is what gives the pair its shape: the weight of the metal stays under the lobe while the upper half stays slim.

The hammered face, close up

The whole outer surface carries an irregular relief with a hammered look. Light lands on it in small broken points instead of reflecting in a single flat highlight, and that is what separates this pair from a polished hoop. From a step away the texture looks like a soft grain; up close it is plainly hammered, with marks that are never quite the same twice. For smoother shapes and lighter drops, see the full earrings range.

What the card states

The packaging carries the marking for stainless steel, grade 316, an alloy widely used for jewellery meant to be worn often. Five things are worth checking before you order.

Keeping a silver tone looking new

A dry cloth after wear covers most of the upkeep, since fingerprints settle in the hollows of the relief and show up more there than on a flat surface. Take the pair off before a shower or a swim, less to protect the steel itself than to keep soap and limescale out of the pattern. Stored flat and away from anything with sharp edges, the pair holds its finish well.